Stratek Plastic Ltd

Extensional / Elongational Flow Mixing

Search Our Site

General Information on

Events

May 16-20, 2010
Orlando World Center
Marriott Resort &
Convention Center
Orlando, Florida USA

June 7 - 10, 2010
Fispal Food Service
Expo Center North
São Paulo - Brazil

Home

Advances in Mixing & Blending

Why settle for this?

10X Magnification
Extruder Only

When you can have this?

10X Magnification
Extruder + Tek-Mix^TM

25% Red pigment in HDPE

25% D&C Red #9 Organic pigment (Lake Red C), single screw extrusion at 10 X magnification, letdown into PE at 2%, shown on a compression molded sheet.

Same product, with Tek-Mix™ Mixer added, letdown into PE at 2%, shown on a compression molded sheet.

While these results come from single screw + Tek-Mix^TM treater processing, for information concerning Tek-Mix^TM improvements in twin-screw processing click here.

Tek-Mix^TM- Extensional / Elongational Flow
The Next Step in Mixing & Blending

< Prev

Latest News

Newsflash

From the Stratek Reading Room...

"The Materials Analyst, Part 98: A Tour of the World of Nylon-Part 1"
An Article by Michael Sepe, published in Injection Molding Magazine - July 2008

Stratek has done considerable experimentation and material processing involving Polyamides (Nylon). Therefore this article caught our eye when we found it in the July Issue of Injection Molding Magazine. We think it addresses both the basics and some more advanced information concerning the differences in the chemistry and structure of these two important materials.